Kichler 300114 Manuel d'utilisateur télécharger pdf (Page 10)

Fig. 18

Fig. 19

NOTE: Before starting installation, disconnect

the power by turning off the circuit breaker or

removing the fuse at fuse box.

Step 1. Loosen the 3 screws from the bottom

of the motor housing.

Step 2. Raise and hold the light kit close to the

motor housing. Connect the white wire

connectors from the light kit and fan. Follow

the same procedure with the black wire

connectors. (Fig. 18)

Step 3. Tuck connections neatly into light kit,

Place the light kit key holes over the 3 screws

previously loosened from the motor housing,

turn light kit until it locks in place at the narrow

section of the key holes. Secure by tightening

the 3 screws previously loosened. (Fig. 18)

11. INSTALLING THE LIGHT KIT

12. INSTALLING THE LIGHT BULBS &

GLASS SHADE

1. Install 3, 40W candelabra bulbs (not

included).

2. Remove the decorative nut, glass cap and

metal nut from the light kit. Place glass shade

over the light kit stem, secure with the metal

nut (rubber side on the top), glass cap and

decorative nut. Do not overtighten. (Fig. 19)

3. Restore power and your light kit is ready for

operation.

Motor housing

Connection plugs

Light kit

Screws

Light kit

Decorative nut

Glass cap

Glass shade

Bulbs

1 2 ... 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

Kichler 300114 Manuel d'utilisateur Page 10