Kichler 15190 Manuel d'utilisateur télécharger pdf

INSTRUCTIONS PERTAINING TO A RISK OF FIRE,OR INJURY TO

PERSONS

IMPORTANT SAFETY INSTRUCTIONS

Lighted lamp is HOT!

WARNING — To reduce the risk of FIRE OR INJURY TO PERSONS.

1) Turn off / unplug and allow to cool before replacing lamp.

2) Lamp gets HOT quickly! Contact only switch / plug when turning on.

3) Do not touch hot lens or cowl.

4) Do not remain in light if skin feels warm. (Light is intense, it may cause

“sunburn”.)

5) Do not look directly at lighted lamp.

6) Keep lamp away from materials that may burn.

7) Useonlywithwattageandlampmarkedonxture.

8) Do not touch the inner glass envelope of the lamp at any time. Use a soft cloth.

Oil from skin may damage lamp.

9) Donotoperatethexturewithadamagedormissinglens.

FOR USE WITH LANDSCAPE LIGHTING SYSTEMS ONLY.

1) The device is accepted as a component of a landscape lighting system

where the suitability of the CSA or UL labeled combination shall be deter

mined by CSA, UL respectively or the local inspection authorities having

jurisdiction.

2) Fixtureshallbeconnectedtoanextralowvoltagetransformerapproved

for use with landscape lighting systems.

3) Thisxtureistobeconnectedtoasecondarywiringofthefollowingtype:

12 GA 60°C minimum type;

SPT-3 suitable for outdoor use; or

approved landscape lighting cable.

CAUTION

WHEN INSTALLING KICHLER LANDSCAPE LIGHTING (LINE VOLTAGE OR LOW VOLTAGE),

CARE SHOULD BE TAKEN TO KEEP CLEAR OF POTENTIALLY COMBUSTIBLE MATERIALS.

WHEN MAINTAINING THE FIXTURES, BE SURE TO REMOVE LEAVES, PINE NEEDLES,

GRASS CLIPPINGS, MULCH, OR ANY DEBRIS THAT HAS ACCUMULATED ON THE LIGHT

BULB, LENS, OR BODY OF THE FIXTURE.

ASSEMBLY AND INSTALLATION

1) Determinedesiredlocationforxtureanddighole.Holeshouldbe

 approximately6”(152mm)indiameterandnomorethan4”(101mm)deep.

2) Twist cover counter clock-wise and remove.

3) Remove lens.

4) Insert recommended lamp into socket.

NOTE: Use caution when installing. Hold lamp by outer housing. DO NOT

touch glass envelope inside. If this happens, clean lamp with denatured

alcohol and a lint free cloth.

5) Reassemble lens and cover to housing. Turn cover until it snaps into

place. NOTE: If O-Ring comes out during assembly, lay O-Ring on ledge

inside of housing before assembling. Do not assemble without O-Ring in

place.

6) Layxtureinholeandbackllaroundthexturewithsoil.

7) Make wire connections using supplied Quic Disc

™

following instructions

below, or using other approved wiring connection method (not supplied.)

DateIssued:12/2/11 IS-15190-CB

OUTDOOR USE ONLY

DOM ETRE INSTALLE A L’EXTERIEUR

INSTRUCTIONS

For Assembling and Installing Fixtures in Canada

Pour L’assemblage et L’installation Au Canada

For warranty information please visit: http://www.landscapelighting.com/portal/warranty_page

Pour de plus amples informations sur la garantie, cliquez sur le lien ci-dessous : http://www.landscapelighting.com/portal/warranty_page

QUIC DISC

™

WIRING INSTRUCTIONS

Turn off power.

Thefulllengthofthe18GAxturewiremaybeusedtoconnectwiththe10GAor12GAcableprovidedthefollowingconditionsaremet:

•Wiringistobeprotectedbyroutingclosetothextureoraccessoryorsecuredtoabuildingstructuresuchashouseordeck.

• 18GAxturewiringistobecutoffsothatitisattachedtotheconnectorwithin6inchesofthextureorbuildingstructure.

• Ifitisnecessarytomaketheconnectionsunderground,thennomorethan6inchesofthe18GAxturewireistobeburied.

The Quic Disc

™

connector is designed to install onextureandaccommodatesone18GAxturewireandone 10 GA or one 12 GA supply wire.

Place the 10 gauge supply wire across the area marked 10 GA on Quic Disc

™

or place the 12 gauge supply wire across the area marked 12 GA

on Quic Disc

™

Placethe18gaugexturewireacrosstheareamarked18GAontheQuicDisc

™

. After the wires are in place, connecta the top of the Quic

Disc

™

tothebasewithsuppliedscrew,makingsurethatthewiresremainatinthebottomportionoftheQuicDisc

™

, and the screw is tightened

all the way down.

Thecoppercontactswillautomaticallypiercethewires’insulation.Excess18GAxturewirethatsticksouttheendoftheQuicDisc

™

is to be cut off.

Makenootherwiringconnectionstothe18GAxturewire.

COVER

COUVERCLE

O-RING

JOINT TORIQUE

LENS

VERRE DIFFUSEUR

LAMP

L’AMPOULE

HOUSING

BOÎTIER

LEDGE

REBORD

1 2

Résumé du contenu

Page 1 - Lighted lamp is HOT!

INSTRUCTIONS PERTAINING TO A RISK OF FIRE,OR INJURY TO PERSONSIMPORTANT SAFETY INSTRUCTIONSLighted lamp is HOT!WARNING — To reduce the risk of FIRE OR

Page 2 - OU DE BLESSURE

INSTRUCTIONS POUR EVITER TOUT RISQUE D’INCENDIE OU DE BLESSUREINSTRUCTIONS DE SECURITE IMPORTANTESUne lampe allumée est BRULANTE!AVERTISSEMENT — Pour

Plus de documents pour Éclairage Kichler 15190

Voir le document Kichler 15190 Manuel d'utilisateur

Kichler 15190 Manuel d'utilisateur (2 pages)

Commentaires sur ces manuels

Pas de commentaire

Kichler 15190 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Kichler 15190. Kichler 15190 Manuel d'utilisation Manuel d'utilisatio

Résumé du contenu

Plus de documents pour Éclairage Kichler 15190

Commentaires sur ces manuels

Produits connexes et manuels pour Éclairage Kichler 15190