search

Kichler 43653 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Éclairage Kichler 43653. Kichler 43653 Manuel d'utilisation Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
    • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
1) Lower long threaded pipe down through bottom center tube.
Pull fixture wire through long threaded pipe and make sure
fixture wire does not get pinched in bottom center tube.
2) Lower first decorative trim piece, decorative sphere then
second decorative trim piece down long threaded pipe. Pull
fixture wire through all three decorative pieces and make
sure fixture wire does not get pinch in between decorative
pieces.
3) Lower fixture body down. Pass top center tube down over
long threaded pipe. Pull fixture wire up at top of fixture body.
Make sure fixture wire does not get pinched in in top center
tube.
4) Pass fixture wire from top of fixture body through short
threaded pipe. Thread end of short threaded pipe into hole in
top of fixture body.
5) Pass fixture wire from short threaded pipe through hole in
center of top trim. Lower top down towards fixture. Pass
hole in top trim over end of short threaded pipe. Set top trim
down on top of fixture body.
6) Pass fixture wire through hole in bottom of top loop. Thread
top loop onto end of threaded pipe protruding from top trim.
7) TURN OFF POWER.
IMPORTANT: Before you start, NEVER attempt any work
without shutting off the electricity until the work is done.
a) Go to the main fuse, or circuit breaker, box in your
home. Place the main power switch in the “OFF”
position.
b) Unscrew the fuse(s), or switch “OFF” the circuit breaker
switch(s), that control the power to the fixture or room
that you are working on.
c) Place the wall switch in the “OFF” position. If the fixture
to be replaced has a switch or pull chain, place those in
the “OFF” position.
8) Take threaded pipe from parts bag and screw in screw collar
loop a minimum of 6 mm (1/4”). Lock into place with hexnut.
9) Run another hexnut down threaded pipe almost touching
first hexnut. Now screw threaded pipe into mounting strap.
Mounting strap must be positioned with extruded thread
faced into outlet box. Threaded pipe must protrude out the
back of mounting strap. Screw third hexnut onto end of
threaded pipe protruding from back of mounting strap.
10) Connect mounting strap to outlet box.
11) Unscrew the threaded ring from screw collar loop. Take
canopy and pass over screw collar loop. Approximately one
half of the screw collar loop exterior threads should be
exposed. Adjust screw collar loop by turning assembly up or
down in mounting strap. Remove canopy.
12) After desired position is found, tighten both top and bottom
hexnuts up against the bottom and top of the mounting
strap.
13) Slip canopy over screw collar loop and thread on threaded
ring. Attach chain (with fixture connected) to bottom of
screw collar loop. Unscrew threaded ring, let canopy and
threaded ring slip down.
14) Weave electrical wire and ground wire through chain links no
more than 3 inches apart. Pass wire through threaded ring,
canopy, screw collar loop, threaded pipe and into outlet box.
15) Connect fixture ground wire to outlet box ground wire with
wire connector. (Not provided.) Never connect ground wire
to black or white power supply wire.
16) Make wire connections (connectors not provided). Reference
chart below for correct connections and wire accordingly.
17) Raise canopy to ceiling.
18) Secure canopy in place by tightening threaded ring onto
screw collar loop.
19) Thread end of threaded pipe with bead into center of socket
cluster.
20) Thread hexnut onto end of threaded pipe.
21) Pass hole in flat washer over end of threaded pipe. Pass
hole in rubber washer over end of threaded pipe.
Date Issued: 8/29/14 IS-43653-CB
Connect Black or
Red Supply Wire to:
Connect
White Supply Wire to:
Black White
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without tracer
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with copper conductor
Insulated wire (other than green)
with silver conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
Neutral Wire
INSTRUCTIONS
For Assembling and Installing Fixtures in Canada
Pour L’assemblage et L’installation Au Canada
SEE OTHER SIDE FOR CANADIAN FRENCH TRANS-
LATIONS.
VOIR L’AUTRE CÔTÉ POUR LES CANADIENS TRA-
DUCTIONS EN FRANÇAIS.
We’re here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
22) Raise glass up to fixture pass hole in glass over end of
threaded pipe.
23) Pass hole in rubber washer over end of threaded pipe
protruding from bottom of glass. Pass hole in flat washer
over end of threaded pipe. Screw hexnut onto end of
threaded pipe.
24) Pass hole in bottom trim over end of threaded pipe.
25) Thread finial onto end of threaded pipe. Tighten finial to
secure glass in place.
MOUNTING STRAP
PATTE DE FIXATION
HEXNUT
ECROU HEXAGONAL
THREADED PIPE
TUBE FILETÉ
SCREW COLLAR LOOP
COLLIER-ÉCROU
CANOPY
CACHE
THREADED RING
BAGUE FILETÉE
LOOP
BOUCLE
GLASS
VERRE
FINIAL
ORNEMENT
RUBBER WASHER
RONDELLE
CAOUTCHOUTÉE
FLAT WASHER
RONDELLE PLATE
HEX COUPLING
ACCOUPLEMENT
HEXAGONALE
BOTTOM TRIM
GARNITURE INFÉRIEURE
THREADED PIPE
TUBE FILETÉ
BEAD
TALON
SOCKET CLUSTER
GROUPE DE DOUILLE
RUBBER WASHER
RONDELLE
CAOUTCHOUTÉE
FLAT WASHER
RONDELLE PLATE
HEXNUT
ECROU HEXAGONAL
TOP TRIM
GARNITURE SUPÉRIEURE
SHORT THREADED PIPE
TUBE FILETÉ COURT
FIXTURE BODY
LUMINAIRE
BOTTOM CENTER TUBE
TUBE CENTRAL INFÉRIEUR
DECORATIVE SPHERE
SPHÈRE DÉCORATIVE
DECORATIVE TRIM
GARNITURE DÉCORATIVE
DECORATIVE TRIM
GARNITURE DÉCORATIVE
TOP CENTER TUBE
TUBE CENTRAL SUPÉRIEUR
SHORT THREADED PIPE
TUBE FILETÉ COURT
LONG THREADED PIPE
LONG TUBE FILETÉ
Vue de la page 0
1 2

Résumé du contenu

Page 1 - 866-558-5706

1) Lower long threaded pipe down through bottom center tube. Pull fixture wire through long threaded pipe and make sure fixture wire does not get

Page 2

1) Abaisser le long tube fileté par le tube central inférieur. Tirer le fil du luminaire à travers le long tube fileté et s’assurer que le fil du l

Plus de documents pour Éclairage Kichler 43653

Voir le document Kichler 43653 Manuel d'utilisateur
Kichler 43653 Manuel d'utilisateur (2 pages)

Commentaires sur ces manuels

Pas de commentaire
Produits connexes et manuels pour Éclairage Kichler 43653
Éclairage Kichler 43653 Manuel d'utilisateur    (2 pages)
Éclairage Kichler 65331 Manuel d'utilisateur    (1 pages)
Éclairage Kichler 43584 Manuel d'utilisateur    (2 pages)
Éclairage Kichler 65345 Manuel d'utilisateur    (1 pages)
Éclairage Kichler 43624 Manuel d'utilisateur    (1 pages)
Éclairage Kichler 65363 Manuel d'utilisateur    (2 pages)
Éclairage Kichler 43624 Manuel d'utilisateur    (2 pages)
Éclairage Kichler 69125 Manuel d'utilisateur    (1 pages)
Éclairage Kichler 43629 Manuel d'utilisateur    (2 pages)
Éclairage Kichler 43640 Manuel d'utilisateur    (1 pages)
Éclairage Kichler 65393 Manuel d'utilisateur    (2 pages)
Éclairage Kichler 65381 Manuel d'utilisateur    (2 pages)
Éclairage Kichler 43654 Manuel d'utilisateur    (1 pages)
Éclairage Kichler 65381 Manuel d'utilisateur    (2 pages)
Éclairage Kichler 65382 Manuel d'utilisateur    (2 pages)
Éclairage Kichler 65382 Manuel d'utilisateur    (2 pages)
Éclairage Kichler 43682 Manuel d'utilisateur    (2 pages)
Éclairage Kichler 65388 Manuel d'utilisateur    (2 pages)
Éclairage Kichler 65388 Manuel d'utilisateur    (2 pages)
Éclairage Kichler 65356 Manuel d'utilisateur    (1 pages)
  • Eberspacher Enernet Deka Ammco Coats Mr. Freeze
  • Philips Chargeurs de batterie Sharp Serveurs d'impression Bogen Équipement musical supplémentaire Central Pneumatic Pistolet à clous Kenwood Accessoires pour la préparation du café
  • Electrolux ENN2754AOW Sony VPL-CX70 Kawasaki 841428 Conair CS28 Casio XJ-UT310WN
  • Samsung Schneider D-XENOGON 35 Manuel de l'utilisateur LG DVX697KH Manuel de l'utilisateur Lectrosonics UCR210d Manuel de l'utilisateur Bertazzoni F30PROXE Spécifications Mitsubishi Electric PAC-AK30BC Manuel d'installation