Kichler 300016 Manuel d'utilisateur télécharger pdf (Page 9)

8

10. INSTALLING THE MOUNTING PLATE

1. Loosen the two screws on the mounting ring

attached to the motor shaft and "remove" and

save the third screw. (Fig. 15)

2. Place the key holes on the mounting plate

over the 2 screws previously loosened from

the mounting ring, turn mounting plate until it

locks in place at the narrow section of the key

holes. Secure by tightening the 2 screws

previously loosened and the one previously

removed. (Fig. 15)

Fig. 15

Mounting

plate

Mounting ring

Screws

52" Canfield Select

TM

Fig. 16

11. INSTALLING THE LIGHT FIXTURE

1. Remove the plastic plug from the center of

the switch housing. Attach the light kit to the

switch housing by feeding the light kit wires

(black & white) through the hole in the center

of the switch housing, then screw the light

fixture stem into the center hole. On the inside

of the switch housing, place a lock washer and

nut on the light fixture stem and tighten.

(Fig.16)

2. Locate the white and blue wires inside the

switch housing labeled FOR LIGHT.

Attach the wires from the light kit to the wires

inside the switch housing by pushing the

polarized connections together.

- White wire to White wire

- Black wire to Black wire

Wire connector

Light kit

assembly

Nut

Lock washer

Switch housing

Plug

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire